|Construction:||Radial arm with interchangeable armtubes.|
|Bearing principle:||DP-6 and DP-8: Dual
mass of complete tonearm with armtube:
can be used with all models.
|Fundamental resonance (depending on armtube):||8 - 14 Hz (for DP-8 N/A for the horizontal mode of motion)|
|Bias compensation:||Watch spring with string - adjustable while playing.|
|Azimuth:||Azimuth is adjustable for correct channel separation.|
|Cueing mechanism:||Piston in U-pipe, damped with silicone fluid.|
|Distance between pivot and center of turnable platter:||9" tube: 212 mm (8
12" tube: 294 mm (11 9/16")
|Overhang:||9" tube: 18 mm (11/16")
12" tube: 13.3 mm (1/2")
|Effective length:||9" tube: 230 mm (9
12" tube: 307.4 mm (12 1/8")
|Diameter of hole for mounting arm base:||20 mm (13/16")|
|Rear overhang from pivot:||70 mm (2 3/4")|
|Offset angle:||24 degrees.|
|Lateral tracking error:||0 degrees at 66 mm and 120.9 mm from center of record.|
|Pivot point:||Pivot point is in level with the record surface.|
|Bearing Friction:||Bearing friction less than 0.04 mN in all directions.|
|Balancing:||Four (4) different balancing weights.|
|Internal wiring:||19 strands of ultra pure silver insulated with Teflon.|
|Capacitance per channel:||28pF for all models.|
|Tonearm Cord:||Balanced. Extremely purified copper strands
that are heavily silver coated. Halogen free insulation. |
Moerch tonearm connector with Cardas RCA connectors.
Capacitance per channel: 100pF.
|Terminals:||All terminals throughout the arm are gold plated.|
|Bearing concept of model DP-6 and DP-8:||One
internally damped, precision ball-bearing assembly for
the horizontal mode of motion.
Two pivoted sapphire bearings for the vertical mode of motion.
|Bearing concept of model UP-4:||Hardened steel pivot resting on a concave sapphire, and damped for all motions with silicone fluid.|
|DP-6 and DP-8 finish:||24 carat GOLD or CHROME.|
|UP-4 finish:||CHROME or at special order GOLD.|
|Weight of DP-8 arm base w/sideweights w/o counterweights and cord:||580 g|
|Weight of DP-6 arm base w/armbush w/o weights and cord:||280 g|
|Weight of UP-4 arm base w/armbush w/o weights and cord:||240 g|
|Weight of a set of counterweights:||120 g|
The right to change specifications without notice is reserved by the Manufacturer.